N.Design Studio

Pond heating

Additional units
Since the previous article was written our members have installed two new systems, and the general layout of these are shown below.
[Eric's heater] This photo shows all the units in place on Eric's boiler, but the roof and doors have yet to be put in place. As this boiler has a conventional flue the roof has to be fixed in place.
[Eric's heater] The boiler used in this case is a Baxi Bermuda back boiler. The fire has of course not been fitted and the flue for this has been blanked off.
In all other respects the system is the same as the one described on the previous page.
The roofing has been completed using modern style tiles.
[Tony's heater] This photo shows Tony's boiler housing. As this had to be fitted into a small area of the patio the unit was built long and thin.
[Tony's heater] All the various components have been laid out in line so that they take up as little space as possible. The depth of the housing is governed by the depth of the boiler.